DTC/STC Truss Clips

The Simpson Strong-Tie STC Roof Truss Clips are used for alignment control between a roof truss and nonbearing walls. The STC has a single 1-1/2" slot that will permit the truss chord to move vertically when loads are applied to the roof. Material: 18 Gauge Finish: Standard G90 Zinc Fasteners: (3) 8d Nails STC Information and Installation Instructions Standard G90 Zinc Galvanized Coating Information Standard G90 Zinc Galvanized Coating contains 0.90 oz. of zinc per square foot of surface area...

The Simpson Strong-Tie DTC Double Slotted Roof Truss Clips are used for alignment control between a roof truss and nonbearing walls. The DTC has two 1-1/2" slots that will permit the truss chord to move vertically when loads are applied to the roof. The double slot increases the allowable load values. Save when purchasing by the box of 100. Material: 18 Gauge Finish: Standard G90 Zinc Fasteners: (6) 8d Nails DTC Information and Installation Instructions Standard G90 Zinc Galvanized Coating...

The Simpson Strong-Tie STCT Roof Truss Clips are used for alignment control between a roof truss and nonbearing walls. Use STCT clips where truss and rafter are separated from the top plate of the non-bearing wall. Material: 18 Gauge Finish: Standard G90 Zinc Fasteners: (3) 8d Nails STC Information and Installation Instructions Standard G90 Zinc Galvanized Coating Information Standard G90 Zinc Galvanized Coating contains 0.90 oz. of zinc per square foot of surface area (total both sides). This...